775 654 443

Gutter repairs: leaks, brackets and downpipes

Most gutter faults can be put right without replacing the whole system. The trouble is that they are noticed only once the facade is visibly wet or the plinth damp, and by then it is two repairs instead of one.

Damaged downpipe outlet on crumbling render

What gets repaired most often

A loose or corroded bracket that has let the gutter drop and changed the fall. A leaking joint between two gutter sections. A cracked or torn downpipe bend, typically after a winter in which water froze inside it. A blocked outlet or a downpipe full of leaves and moss. A missing or broken shoe, which sends the water straight onto the plinth.

When a local repair is enough

When the metal as a whole is sound and the fault is local. Replacing a few brackets, lapping a joint, swapping one bend or adding a missing part is quick work, and there is no sense in changing the whole system for it.

When a repair only postpones replacement

When the metal is perforated by corrosion along its whole length, not in one spot. When the system was made of the wrong material for the metals around it, because then corrosion carries on regardless of the patch. And when the fascia board the brackets are fixed into has rotted: there is nothing left to screw into.

Clearing out as part of the repair

A clogged gutter is itself a cause of faults. Water overflows the edge through leaves and moss, a damp layer sits in the gutter and speeds up corrosion, and ice holds in it through the winter. A firm clears a clogged gutter as part of a repair, because otherwise there is nowhere to work.

What to put in your enquiry

Where it leaks and when, whether in every shower or only in a downpour, and how high up it is. A photo of the spot and a photo of a corner of the building say more than a paragraph. If you know what the existing system is made of, write it down.

Frequently asked questions

Water comes over the edge of my gutter. Is it too small?

Not necessarily. A gutter clogged with leaves behaves the same way, so does one with no fall that holds standing water, and so does one with a blocked outlet. Too narrow a developed width is one possible explanation, not the first one to reach for.

Can a cracked downpipe be repaired, or is it all replaced?

Usually only the damaged section or bend is swapped. The exception is a downpipe that cracked because water freezes in it every year. There the cause is dealt with too, for instance the fall of the gutter or a heating cable.

How often should gutters be cleared?

Mostly it depends on what grows around the building. A house under broadleaf trees needs checking far more often than one in the open. A sensible rhythm is to look at the gutters after autumn and before winter.

Describe the job

A few sentences and the location are enough. We read every enquiry and pass it to a sheet metal firm that works in your area. If we have nobody there, we tell you straight away.